Shaving machine product details

The cutting machine is a kind of tool which is finished with the main structure surface, so that the construction surface of the two construction phases is firm. Generally, the machine is used in the online casting concrete structure, in the cast in place after the completion of the board, to cut the hair, the next layer of pouring, so that the concrete bond firm. Therefore, the "chisel machine" is generally referred to as "concrete cutting machine".

Examples of application of the chisel machine

1, the bridge surface waterproof treatment of wool.

2, high speed railway box girder (precast beam) of the beam surface waterproof treatment of wool.

3, the bridge side, bridge end face, Liang Ce, beam end of concrete.

4, remove ground coating, paint, traffic marking.

5, cleaning, removal of the airport runway road marking, tire braking marks, to obtain a rough surface friction coefficient is very high.

6, the surface treatment of cement asphalt pavement, bridge deck, bridge fault, epoxy resin wear-resisting floor.

7, the road of micro surfacing construction, to the original old pavement cutting hair removal, preparing for slurry seal.

Development and application of the chisel machine

The traditional method of cutting the hair of the machine is to use a sharp impact tool in the concrete surface of the piston hit, so that the new and old concrete bonding firm. However, the traditional method of cutting has a variety of drawbacks, such as low efficiency, mechanical vibration caused by acoustic transmission, damage to the main body of the chisel to cut the main body of the life. At present, in view of the small area of the chisel (part of the chisel, the face of the chisel, the side of the chisel, the top surface of the chisel), you can use a hand-held small chisel, the effect is good, and will not cause damage to the original structure. Because now the chiseling machinery products will not only destroy the protective layer of reinforced concrete, and will cause damage or even catastrophic damage to the structure of the original, so now in many engineering especially for bridges and tunnels concrete chisel chisel to break, a lot of large machinery chiseling machine has been banned. At present the most used and most secure is the high-pressure water jet, "non destructive chisel".