Fixed obstractor product details

A stopper is fixed according to the actual situation of the use of units, designed to meet the specific requirements of the use of units of products. The utility model has the advantages of short occupation line, simple structure, low cost and convenient maintenance. The utility model can be used in the occasions where the vehicle is smaller and the impact speed is not high.

Fixed stopper technical parameters

Maximum speed of vehicle impact: according to user needs, can provide 3, 5, 7km/h a total of 3 grades. The buffer head shape and size: the standard vehicle for plane type, subway, light rail and other vehicles and provide users with the coupler size and shape matching. The height of the center of the buffer head from the rail surface: standard rail vehicles: 850mm Metro and light rail vehicles: 500mm, 660mm, 678mm, 720 mm, other vehicles provided by the user data, according to the actual design.

The installation method of fixed stopper

The left arm and the right arm are placed on the basic rail and are connected with the support by the arm pin shaft.

Lift the arm, and the spring seat, the plate spring and the bearing seat are arranged on the basic rail below the shoe type.

The brake hoof block will be caught, but also a basic rail rail clamp, with three bolts of the braking rail belt. Note that the two bolts on the outer side must pass through the supporting frame.

4 use the front and rear beam and the lower beam two arm below four feet are connected, the overlapping form, two middle and four oblique angle with the pin belt. Complete the above installation, tighten all bolts.

The use of the pressurizer spring plate pressure: U shaped pressure quickly inserted on both sides of a bearing seat is installed in the neutral, pressurized pressure screw rod head is center nut alignment pressure block, hanging on the hook on both sides of the rail pressure plate on the base track on the floor, with a nut, with a length of about 1.5 meters of iron screw press the screw and the wedge between the bearing and the plate into the spring plate, the spring and the spring seat clearance is 0.6 + 0.05 mm.

The sign will be mounted on a support.

The time should be installed in orbit at the waist position mark painted, to facilitate the daily check whether the damaged car stopper.

The products have been exported to the United States, France, Canada, Indonesia, Russia, Vietnam, Australia, South Korea, Iran and other countries, to obtain customer acclaim.